Marsh 241D App Error Codes List - marshcoding - 码可迪中国官方商城

Hello, what are you looking for?

Marsh 241D App Error Codes List

This FAQ contains a complete list of all error codes displayed on the Marsh M241D App.

The Marsh241D utilises the Marsh mobile app to provide support should a customer encountering problem with their M241D coder.

If the Marsh 241D encounters a fault – LED’s on the user interface will illuminate red (both red LEDS below with be illuminated). 

To see the error and its meaning from the list below, please connect the M241D app to the coder, selected the red fault banner at the top and the screen. The list of all errors displayed on the Marsh App are listed below:

 

Error Number

Title

Description

000

Ribbon Snapped (000)

Re-thread ribbon.

001

Ribbon Removed (001)

Fit new ribbon roll.

002

Print Cycle Error (002)

The print cycle did not complete properly. Press clear, but if the problem persists, repower the coder.

003

Printhead Sensor Dirty (003)

Remove printhead and clean the sensor and sensor target.

004

Printhead Actuator Disconnected (004)

Check 2-pin connector on printhead.

005

Platen Gap Too Large (005)

Use Gap Setting Tool to set correct printhead-platen distance.

006

Printhead Stuck Out (006)

Check printhead for obstructions and push printhead in.

007

Printhead Stuck In (007)

Check printhead for obstructions.

009

Out of Ribbon (009)

Fit new ribbon roll.

010

Ribbon Waste Too Large (010)

Remove waste, fit new waste core and re-thread ribbon.

011

Ribbon Waste Core Missing (011)

Fit waste core and re-thread ribbon.

012

Wrong Size Ribbon (012)

Fit Marsh 241D ribbon.

013

Ribbon Supply Sensor Dirty (013)

Remove ribbon from supply. Clean the ribbon supply sensor then refit the ribbon

014

Printhead Absent (014)

Check Printhead connection and check printhead is MARSH serial number {0}

015

Printhead Absent (015)

Check Printhead connection and check printhead is MARSH serial number {0}

016

Ribbon Advance Fault (016)

The ribbon advanced unexpectedly. Check that the coder is properly mounted and that the printhead-platen distance is correct. Check also that the ribbon and substrate paths are correct.

017

Printhead Absent (017)

Check Printhead connection and check printhead is MARSH serial number {0}

018

Time and Date Corruption Detected (018)

The coder has detected a corruption of its time and date. Connecting the app has corrected the problem. If this warning persists, replace coder PCB.

019

Printhead Clean Recommended (019)

Scheduled printhead cleaning is recommended.